![]() ![]() The restore may fail with status code 5 if the SQL connection has been taken by a user or another application. \Veritas\NetBackup\bin\dbbackex.exe -f "\ scriptname.bch"Ĥ. For rapid start, it is recommended to run the restore from command line using dbbackex.exe command. As soon as the SQL Server instance starts in single user mode, launch the restore. SQL Server Agent must be stopped so it does not take over the SQL Server connection, however do not set the service toĭisabled as NetBackup will attempt to start it after recovery.ģ. Stop the SQL Server instance and start it again in single-user mode by following Use replace option and leave the consistency check option as Restore SQL Server objects and locate the backup image to restore. Before restarting the SQL Server instance in single user mode, launch the NetBackup MS SQL Client GUI. This procedure assumes the SQL Server instance can start without problem either by rebuilding existing master database or installing a fresh SQL Server software.ġ. In clustered SQL Server setup, the restore should be run on the active node. NetBackup Client Service must be run by an account with SysAdmin privilege.Ĥ. NetBackup master and media servers must be able to resolve client's host name/IP address and vice versa.ģ. ![]()
0 Comments
Leave a Reply. |